Unable to Reset Rockspace AC1200 Extender. Help!

We all need a new start at some time or the other in our lives. So can be the case with your technical gadgets as well. If you are looking to reset your Rockspace extender AC1200 but can not complete the task at hand then you need not worry anymore as you have landed on the right post. Here you are not only going to get the best troubleshooting hacks to fix the issue but we will also tell you the exact steps to execute the Reset process. After the reset is done, you can then easily complete the Rockspace AC1200 extender setup process without any hassle.

How to Reset Rockspace WiFi Extender?

1. Get near the Rocksapce wireless range extender.

2. Ensure that it is connected to a power socket and is turned on.

3. Locate and press the Reset button on it.

Your Rockspace extender is now reset and is running on the factory settings. If these instructions haven’t been able to help you to complete the reset process then use the hacks that we have discussed ahead.

How to Fix Rockspace Extender Reset Issues?

1. Reboot the Extender

Before you try to perform the reset process, we want you to once reboot the extender. This helps in eliminating temporary glitches from the extender. You can reboot the extender by using the instructions given ahead:

• Disconnect the extender and router.

• Turn off the power supply to the extender.

• Remove the power socket from the wall outlet.

• Let the device be in this state for a couple of minutes.

• Connect the power cable once again.

• Turn on the extender from its power button.

Try to complete the reset process now. If you still fail in doing this, then try the next hack from this list.

2. Check the Power Supply

The Rockspace wireless extender AC1200 should be receiving a stable power supply from its power socket. In case the power socket is broken then you will face issues in resetting the extender. Another possibility is that the power cable is loose or damaged. Get the cable replaced or plug the extender into another power socket. Be very certain that the power supply is adequate. After fixing the power supply, you should try to perform the reset process.

3. Press Correct Button

In case you are trying to reset your Rockspace extender AC1200 using the hard reset method, then make sure that the button that you are pressing is the Reset button.

4. Check Hardware Damage

There is a possibility that hardware damage on your Rockspace extender is not letting you complete the job at hand. Maybe the Reset button itself is damaged. In such a situation you can use the Soft reset method to do this work. In that, you need to access the settings of the Rockspace extender and then reset the device from there. Here are the instructions for the same:

• Turn your extender on.

• Ensure to connect it to the host router.

• Use your computer or laptop and load up an internet browser on it.

• Log in to the admin panel of the Rockspace extender next.

• Upon logging in, you will reach the settings.

• Go to the Administration option.

• Click on the Reset option and the reset process will begin after a confirmation message.

To Briefly Conclude

Right after you are done with resetting your Rockspace AC1200 extender, you need to set it up once again. After the setup is done, you can easily access the extender WiFi via Rockspace_ext.